+90 318 225 20 02

Beyfix High Performance Elastic Ceramic Adhesive Mortar

Beyfix High Performance Elastic Ceramic Adhesive Mortar

DEFINITION
Cement-based, polymer-added, highly adhesive tile and ceramic adhesive with with reduced slippage.
AREAS OF USE
It is used for horizontal and vertical bonding of ceramics and tiles to cement-based grout and alum surfaces at interior spaces.
ADVANTAGES
It is easy to prepare and apply. Provides sufficient working time. It does not slip in vertical applications. Provides high adhesion properties.
SURFACE PREPARATION
Application surface should be clean and free of loosen surfaces and dust, which prevent adhesion. Corrupt surfaces, cracks, and fractures should be repaired with fine repair mortar and coarse repair mortar 24 hours before application. Surface should be moistened before applying adhesive mortar. Before applying onto surfaces with high liquid absorption capacity such as gypsum or gypsum board and onto old ceramic-coated surfaces an appropriate BEYFİX surface primer should be applied.
INSTRUCTIONS OF USE
25 kg of HIGH PERFORMANCE ELASTIC CERAMIC ADHESION MORTAR is slightly poured into 6-7 l of water at ambient temperature between + + 5 °C and + 35°C and mixed by a mixer with low revolution (400-600 rpm) to obtain a homogeneous mixture. The mortar prepared is left to mature by 5-10 minutes, after which it is further mixed by 1-2 minutes before starting application. The mortar spread by flat side of trowel is then combed with toothed trowel suitable for dimensions of the tile. Ceramics should be adhered onto combed mortar in 20 minutes. Expired and sloughed mortars should not be used. Air behind the ceramic should be discharged by means of rubber hammer for good adhesion. Joint gaps may be filled with BEYFİX Joint Sealant Mortar 24 hours has passed over adhesion.
PACKAGE
It is 25 kg craft bag. (PE reinforced)
64 bags of shilling in one pallet (106 x 106 cm)
STORAGE AND SHELF LIFE
Maximum 2 palettes could be superimposed in closed original packaging and under cool and dry ambient. Shelf life is 12 months under proper storage conditions after manufacturing date.
SAFETY PRECAUTIONS
Gloves should be used during application. Areas contacted to product should be washed with plenty of water. If swallowed, call for a physician, immediately.

QUALITY STANDARD
Complies with TS EN 12004-1:2017 / C1T quality standard.
1: Standard performance
T: Reduced slippage
Conforms to CE Communiqué

AppearanceWhite or gray colored powder.
Mixing Ratio6-7 l of water / 25 kg of powder
Consumption3-5 kg/m2
Application Temperature+5°C to +35°C
Open dwell time20 minutes
Dwell Time in container4 hours
Time for suitability to pe- destrian traffc24 hours
Time for applying joint24 hours
Adhesion Resistance Initial ≥ 1 N/mm2
After Temp. Aging ≥ 1 N/mm
After submerging ≥ 1 N/mm
After freeze-thaw cycle ≥ 1 N/mm
Slippage≤ 0,5 mm
Elasticity≥ 2,5 and ≤ 5,0 mm – S1 (Flexible)
Temperature Endurance-30°C to +60°C
en_USEnglish